- Purchased large hole saw and engine pre-heater wire
- Fabricated long pilot shaft for large hole saw
- Hole saw cut heater exhaust opening in habitat floor
- Machined aluminum sleeve to finish heater passthrough hole
- Bonded aluminum sleeve into heater passthrough hole
- Replaced air dryer cartridge
- Spliced engine pre-heater wire
- Bonded oak trim to lower edge of bed opening
- Measured width of shower tray edge
- Received water tank quick disconnect fittings
- Laid out bed deck on plywood
- Researched water tank barb bulkhead fitting options
- Cut bed deck
- Started detail design of shower drains
- Finalized design of water tank pick up and vent
- Machined AN-4 bulkhead fitting into tank barb fittings
- Finalized layout of bed deck ventilation
- Worked on under subframe box locking ideas
- Ordered ceiling track for shower curtain
- Ordered battery cutoff switches
Fabricated long pilot shaft for large hole saw
Hole saw cut heater exhaust opening in habitat floor
Hole saw cut heater exhaust opening in habitat floor
Hole saw cut heater exhaust opening in habitat floor
Machined aluminum sleeve to finish heater passthrough hole
Machined aluminum sleeve to finish heater passthrough hole
Machined aluminum sleeve to finish heater passthrough hole
Machined aluminum sleeve to finish heater passthrough hole
Machined aluminum sleeve to finish heater passthrough hole
Bonded aluminum sleeve into heater passthrough hole
Bonded aluminum sleeve into heater passthrough hole
Bonded aluminum sleeve into heater passthrough hole
Replaced air dryer cartridge
Bonded oak trim to lower edge of bed opening
Bonded oak trim to lower edge of bed opening
Received water tank disconnect fittings
Laid out bed deck on plywood
Machined AN-4 bulkhead fittings into tank barb fittings
Machined AN-4 bulkhead fittings into tank barb fittings
Machined AN-4 bulkhead fittings into tank barb fittings
Machined AN-4 bulkhead fittings into tank barb fittings
Wabi-sabi Overland 