- Purchased hardware to finish seat bases
- Ordered material for heater exhaust passthrough
- Finalized layout of heater installation
- Finalized layout of charge controller installation
- Upholstered and assembled seat bases
- Received material for heater exhaust passthrough
- Installed aluminum support under outboard water jerry can
- Installed charge controller and Victron batter monitor shunt
- Test fit aft under subframe storage
- Final positioned heater and through drilled alignment hole
- Applied second coat of paint to aft dinette bench
- Changed out under bed LED strip lights (adhesive was failing)
- Color labeled high current wires
- Test fit heater exhaust hose
- Installed smoke / CO detector
- Installed digital inside / outside thermometers
- Test fit Omnia oven in kitchen drawer
- Sealed wire passthrough holes
- Started running power for engine pre-heater
- Measured bed deck dimensions
- Spliced wire extension for water pump under sink
- Ordered 60mm flanges from Heatso
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Upholstered and assembled seat bases
Installed aluminum support under outboard water jerry can
Installed aluminum support under outboard water jerry can
Installed charge controller and Victron battery monitor shunt
Installed charge controller and Victron battery monitor shunt
Rest fit aft under subframe storage
Final positioned heater and through drilled alignment hole
Final positioned heater and through drilled alignment hole
Applied second coat of pain to aft dinette bench
Changed out under bed led strip lights (adhesive was failing)
Installed smoke/CO detector
Installed digital inside/outside thermometers
Installed digital inside/outside thermometers
Wabi-sabi Overland 