Truck Update 12/5/18

  • Received GPS backup speedometer
  • Received brake bleeder
  • Received shower fixture
  • Installed passenger side exterior wall table mount rail
  • Painted passenger side exterior wall table mount rail
  • Sealed bed rail support seams with paintable silicone
  • Located awning on exterior of habitat
  • Drilled awning mount holes
  • Fit checked, prepped, bonded, and screwed passenger overhead cabinet
  • Prepped and bonded awning mount plates
  • Received awning hardware from McMaster-Carr
  • Removed water tank from habitat to start designing tank mount
  • Test fit brake bleeder
  • Filled screw holes in bedroom wall
  • Made hair dryer plastic bubble heater for curing awning mount bond
  • Painted all exposed wood in bed area
  • Applied first coat of paint to rear passenger and driver side bed walls
  • Measured rear roof access ladder to ground clearance
  • Measured alternate habitat entry ladder height
  • Prepped, bonded, and screwed over bed cabinets on rear bed walls
Advertisements