Truck Update 11/14/18

  • Finished all trim and flanges on bedroom walls
  • Cut plywood for lower bed wall
  • Carefully reviewed wall design and dimensions
  • Bought painting supplies
  • Painted hard to access wall flanges prior to assembly
  • Clearanced bedroom walls for extrusions
  • Fit checked cabinet to driver side bedroom wall
  • Painted difficult to access area on wall behind cabinet
  • Sprayed top coat paint on upper kitchen cabinet and doors
  • Notched baseboard for extrusion
  • Pre-drilled and countersunk assembly screw holes in all wall components
  • Cut 1/2″ wide spacer for bed wall entry area
  • Dry fit, masked, prepped, bonded, screwed, and assembled bed wall into habitat
  • Cut wood to finish bed entry opening
  • Fit riser block to bottom of kitchen cabinet
  • Match drilled holes from riser into bottom of kitchen cabinet
  • Installed bed entry opening finish trim
  • Installed bed wall baseboard
  • Filled exposed screw holes on forward face of bedroom wall
  • Installed hinges and doors on upper kitchen cabinet
  • Disposed of unneeded lumber
  • Dry fit, masked, prepped, bonded, screwed, and installed upper kitchen cabinet
  • Touched up Korapop 225 wall bond where clamps blocked access
  • Started cutting kitchen cabinet faces
  • VHB bond test on painted wood
  • Corresponded about portal axle reservoir tanks
  • Corresponded about speedometer/odometer upgrade
  • Received:
    • Cab speakers
    • Fuel pump primer
    • Air dryer desiccant cartridge
    • Charge controller
    • Battery monitor
  • Started designing bracket for seagull water filter
  • Fabricated and installed shelves, mounting plate, and support spacers inside kitchen cabinet
  • Masked and applied first coat of paint to forward side of driver side bed wall
  • Dry fit, masked, prepped, bonded, screwed, and installed kitchen cabinet riser
Advertisements