- Purchased the majority of the lumber and plywood for habitat interior
- Cut wood and started assembling kitchen upper cabinets
- Finished design and started fabricating bed walls
- Bonded and screwed lower bed wall member to habitat floor
- Assembled and bonded upper kitchen cabinet face
- Ordered cabinet latches
- Glued/screwed upper kitchen cabinet face
- Finalized size of plywood for kitchen walls and upper kitchen cabinets
- Corresponded with Battle Born about charge controllers
- Requested information on portal axle oil reservoir options
- Cut plywood for:
- Kitchen walls
- Upper kitchen cabinets
- Bathroom wall
- Kitchen pantry
- Assembled upper kitchen cabinet
- Modified lower kitchen cabinet support base
- Started painting:
- Base board
- Back of lower kitchen cabinet
- Mid lower bed wall
- Purchased trim to finish edge of plywood
- Ordered Victron charge controller and battery monitor from Battle Born
- Cut and installed upper kitchen cabinet dividers
- Bonded edge trim to bed walls
- Filled screw holes and sanded upper kitchen cabinet
- Sanded edges of bed walls
- Cut wood for bed support
- Assembled, glued, and screwed bed support rails
- Painted upper cabinet
- Painted lower kitchen cabinet support
- Received water strainer and accumulator
- Fit checked, prepped, bonded, and screwed bed support rails into habitat