- Chamfered edges of rear wall panel
- Prepped and bonded steel hardpoints in rear wall panel
- Tack welded tire mount ladder brackets
- Fabricated and test fit tire boom hoist side strut
- Fit checked rear extrusions
- Trimmed 1/8″ from upper and lower rear extrustions
- Positioned tire mount on rear panel
- Clearance checked tire mount with extrusions
- Match drilled pilot holes for tire mount on rear panel
- Cut and labeled wiring for installation of rear panel
- Installed and wire wrapped rear panel wiring
- Prepped and bonded lower extrusion to rear panel
- Drilled wiring hole for fantastic fan
- Repositioned rear panel on shop floor
- Marked location of solar panel wire passthrough on roof
- Planned rear wall bond sequence
- Drilled wiring holes for interior spotlights
- Drilled wiring hole in roof panel for solar wiring
- Ran wiring on back edge of roof panel
- Bonded driver side vertical extrusion on rear panel
- Prepped and final bonded rear panel (last panel bond!)
- Removed clamps from rear panel
Chamfered Edages of Rear Wall Panel
Prepping Steel Hardpoints for Rear Panel
Prepped for Rear Wall Steel Hardpoint Bond
Steel Hardpoint Rear Wall Bond
Drilling and Tapping Mid Span Clamp Up Bolts for Rear Wall Hardpoint Bond
Steel Hardpoint Rear Wall Bond Complete
Tire Mount Ladder Brackets
Tack Welded Tire Mount Ladder Brackets
Test Fit Tire Boom Hoist Side Strut
Fit Checking Rear Extrusions
Positioned Tire Mount on Rear Panel
Match Drilled Pilot Holes for Tire Mount on Rear Panel
Installed and Wire Wrapped Rear Panel Wiring
Installed Rear Panel Wiring
Bonded Lower Extrusion to Rear Panel
Ran Wiring on Back Edge of Roof Panel
Ran Wiring on Back Edge of Roof Panel
Bonded Driver Side Vertical Extrusion on Rear Panel
Final Bonded Rear Panel
Final Bonded Rear Panel – Last Panel Bond!
Removed Clamps from Rear Panel
Habitat Internal View After Panel Bonds Complete
Wabi-sabi Overland 