- Fabricated standoffs for distribution panel shield
- Fabricated high current positive bar for distribution panel
- Purchased material for refrigerator mount
- Cut lumber and bonded refrigerator slide mounts
- Purchased foam for dinette cushions
- Purchased trim lumber for refrigerator opening
- Installed distribution panel
- Wired distribution panel from switch panel
- Cut opening for refrigerator slide in lower bed wall
- Installed trim around refrigerator opening
- Bonded refrigerator slide mount to habitat floor using Korapop 225
- Measured and started design work for:
- Under bed divider
- Aft dinette bench
- Riser for forward dinette bench
- Fabricated under bed storage bins out of old water tank
- Cut access opening in top of calorifier cabinet
- Trimmed away unneeded wood on aft table support
- Clearanced pantry trim near sink cabinet door
- Painted
- Calorifier cabinet
- Aft table support
- Refrigerator mount
- Trim around refrigerator mount
- Pantry trim
Fabricated standoffs for distribution panel shield
Fabricated standoffs for distribution panel shield
Fabricated high current positive bus bar for distribution panel
Installed distribution panel
Installed distribution panel
Cut lumber and bonded refrigerator slide mounts
Cut opening for refrigerator slide in lower bed wall and installed trim around opening
Cut opening for refrigerator slide in lower bed wall and installed trim around opening
Bonded refrigerator slide mount to habitat floor using Korapop 225
Bonded refrigerator slide mount to habitat floor using Korapop 225
Painted refrigerator mount and trim around refrigerator opening
Cut access opening in top of calorifier cabinet
Cut access opening in top of calorifier cabinet
Painted calorifier cabinet
Trimmed away unneeded wood on aft table support
Painted aft table support
Painted pantry trim
Fabricated under bed storage bins out of old water tank
Wabi-sabi Overland 